Electrolux ICON E30MH65GPS General Installation Manuallines page 2

Over-the-Range Microwave
E30MH65GPS professional series
Locate 120V/60Hz grounded outlet inside upper cabinet
Microwave MUST
be mounted to
BOTH a top cabinet
AND a wall*
16 1
min.
69"min.
from floor
to top of
microwave
30" Over-the-Range Microwave Specifications
Product Weight – 75 Lbs.
•
Voltage Rating – 120V / 60 Hz / 20 Amp
•
Connected Load (kW Rating) @ 120 Volts = 1.6 kW
•
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded for
safe operation.)
Amps @ 120 Volts = 14.5 Amps
•
Always consult local and national electric codes.
•
Grounded outlet should be located in cabinet above, with hole in base
•
to route power cord. Carefully follow top template instructions for power
cord clearance when installing beneath smooth, flat cabinets.
Microwave's ventilation system is preset to recirculate air inside with no
•
ducting system required. Exhausting air outside is optional, using either
vertical or horizontal ducting system. (Refer to Ducted Option
Specifications for outside ventilation.)
For safe and proper installation, microwave MUST be mounted to
•
BOTH a top cabinet AND a wall, and connected to at least one wall stud.
Can NOT be installed in island or peninsula cabinet arrangements.
Cabinet bottom MUST be level to insure proper installation.
•
Cabinet MUST be capable of supporting a total load of 110 lbs.
•
Filler blocks recommended for installation when cabinet front hangs
•
below recessed bottom shelf.
Minimum distance of 33" required from cooking surface to bottom
•
edge of top cabinet.
Minimum distance of 69" required from floor to top of microwave.
•
Opening between cabinets MUST be 30" wide and free of obstructions.
•
Can only be installed over ranges or cooktops with 33" maximum width.
•
Allow 25-1/2" minimum clearance for 90° door swing.
•
Electrolux Major Appliances, N.A.
USA 10200 David Taylor Drive Charlotte, NC 28262
• •
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
E30MH65GPS 08/11
30"
/ "
Rear Wall
2
12"
min.
min.
30"min.
5"min.
Backsplash
30"min.
33"max.
*Can NOT be installed
in island or peninsula
cabinet arrangements
1-877 -4electrolux (1-877 -435-3287)
•
1-800-265-8352
• •
© 2011 Electrolux Home Products, Inc.
Bottom edge of
cabinet MUST be
33"min. from
cooking surface
Cabinet MUST
be capable of
supporting a total
load of 110 lbs.
Blower plate allows for vertical
or horizontal ducting
16 3 / "
8
16 7 / "
8
1 / " lower
2
extrusion
3
14 / "
8
16 1 / "
8
Ducted Option Specifications
For outside ventilation.
•
Exhaust duct adapter supplied assembled for outside ventilation,
•
designed to mate with standard 3-1/4" x 10" rectangular duct. If round
duct required, rectangular-to-round transition adapter will be needed
with no less than 6" diameter.
For most efficient airflow exhaust, use a straight run or as few elbows
•
as possible with maximum duct length of 3-1/4" x 10" rectangular
or 6" diameter round duct, not to exceed 140 equivalent feet.
For horizontal installation, be sure to allow enough space between wall
•
studs to accommodate exhaust.
Refer to installation instructions on web for detailed duct preparation and
•
converting exhaust vent blower system for exterior exhaust ventilation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
Optional Accessories
36" Filler Panel Kit – (PN # MWFILKTSS).
•
electroluxicon.com
•
electroluxicon.ca
Power cord location
(right top rear)
29 7 / "
8
Allow at least 25 1 / " clearance
2
for door depth when open
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Printed in the U.S.A.