Hardware Installation - Vivotek IP8330 Quick Installation Manual

3

Hardware Installation

1. Loose the waterproof connector, then remove the rubber.
2. Loose the back cover.
3. Tear down the aluminum foil vacuum bag and take out the silica gel. Attach the
supplied silica gel to the inner side of the Network Camera. (Please replace the silica
gel with a new one if you open the back cover after installation.)
4. Make sure all cable lines are securely connected.
5. Tighten the back cover, rubber and waterproof connector.
6. Secure the Network Camera to the wall/ceiling by the supplied camera stand.
3
Note
If you want to use your own cable lines, please loose two supplied screws and take out
the power board. Then be careful to make connections as the illustration shown below.
Power Cord
Screws
2
1
5
6
Wall Mount
Ethernet Cable
Terminal Block (from left to right)
EN-4
Ceiling Mount
1: AC24V (red)
2: AC24V (red)
3: DI (white)
4: GND (black)