Mowing Tips - sunjoe MOW JOE MJ502M Operator's Manual

Adjusting the mower blades
1. Each end of the cutting bar can be adjusted separately.
2. The cutting bar blade, which is located under the reel, is
able to pivot. The two adjustment nuts located at the back
of the mower move the cutting bar away from the blades
when they are turned counterclockwise, and closer to the
blades when they are turned clockwise (Fig. 9).
Fig. 9
m WARNING!
Do not overtighten the adjustment screws
as this could damage the cutting bar. Both screws must be
tight on final adjustment.
3. To loosen the blades, use the hex wrench provided and
turn both adjustment screws by an equal amount
counterclockwise.
4. To tighten the blades, tighten both screws by an equal
amount by turning them clockwise.
NOTE: If you have any questions, please call the Snow Joe
Sun Joe customer service department at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
Adjustment
screw

Mowing Tips

Follow the 1/3 rule
The 1/3 rule is key to an enjoyable mowing experience and a
healthy lawn.
+
®
8
5. Once the mower blades have been properly adjusted and
their alignment has been verified, you can now proceed
to use your reel mower. Align the cutting path indication
arrow with the previously cut path (Fig. 10).
NOTE: The width of the reel mower's actual cut is
indicated below. Do not use the mower's wheels as a
reference point for the grass cut line.
Fig. 10
20 inches
1. You should mow your lawn regularly, at least once a week,
during the growing season.
2. Be guided by observing the lawn and taking care not to
remove more than 1/3 of the total height of the turf at any
mowing session and never more than 1 inch at a time
(Fig. 11).
Fig. 11
1/3
1"