Speaker Connections - Teac CR-H226 Owner's Manual

A

Speaker Connections

Caution:
< To avoid damaging the speakers by a sudden
high-level signal, be sure to switch the power off
before connecting the speakers.
< Check the impedance of your speakers. Connect
speaker with an impedance of 6 ohms or more.
< The amplifier's red speaker terminals are the +
(positive) terminals and the black terminals are the
_ (negative) terminals.
The + side of the speaker cable is marked to
make it distinguishable from the negative side of
the cable. Connect this marked side to the red +
terminal and the unmarked side to the black _
terminal.
< Prepare the speaker cords for connection by
stripping off approximately 10 mm or less (no
more as this could cause a short-circuit) of the
outer insulation. Twist the wires tightly together
to avoid tangles:
How to connect
1. Turn the terminal cap counterclockwise to loosen
it. The speaker terminal caps cannot be fully
removed from the base.
2. Insert the wire into the terminal fully and turn the
terminal cap clockwise to securely connect it:
3. Make sure it is fastened firm by pulling the cable
lightly.
For European customers
In accordance with European safety regulations, it
is not possible to connect banana plugs into the
speaker terminals on European models.
The holes into which banana plugs are inserted
have been covered with black caps. Connect the
speakers using spades or bare wires.
If the black caps become separated from the
terminals, return them to their original position.
B
SUBWOOFER OUT jack
Connect a commercially available powered
subwoofer.
9