Nintendo 2DS Operation Manual page 30

Connecting using AOSS
If your access point supports AOSS, you can set up a connection quickly and easily. Refer to the instruction manual for your access point in
addition to this manual.
Note: Using AOSS may cause your access point settings to change. If your computer is connected to the access point without using AOSS, it may
no longer be able to connect after using AOSS. Establishing a connection using an access point found through a search will not change any
of the access point's settings (page 60).
Touch AOSS
1
Note: If you are using the tutorial and you have selected
2
Steps for the access point
Press and hold the AOSS button on the access point until the AOSS light
flashes twice in succession.
Note: If you have tried and failed several times to set up a connection using AOSS, wait
approximately 5 minutes before trying again.
Once the Setup Complete Screen appears, touch OK to begin a connection test
3
•
If the test is successful, setup is complete.
•
Failure to establish a connection can sometimes occur after AOSS setup is complete. If this happens, please wait a short while
before trying to reconnect.
58
2
, start from step .
AOSS button
Connecting using Wi-Fi Protected Setup
You can set up a connection quickly and easily using Wi-Fi Protected Setup. Refer to the instruction manual of your access point for further
information.
Note: If the security type for your access point (page 60) is set to WEP, you will not be able to connect using Wi-Fi Protected Setup.
Touch
1
Note: If you are using the tutorial and you have selected , start from step
Touch the connection method supported by your
2
access point
Steps for the access point
3
Note: It may take around 2 minutes to complete setup.
For Push-Button Connection
Press and hold the Wi-Fi Protected Setup button on the access point
until the LED blinks.
For PIN Connection
A PIN will be displayed on the Touch Screen. Enter the code into the
access point settings, then touch NEXT.
Note: After configuring the access point, touch NEXT on the Touch Screen of your
Nintendo 2DS system.
Once the Setup Complete Screen appears, touch OK to begin a connection test
4
•
If the test is successful, setup is complete.
•
Failure to establish a connection can sometimes occur after Wi-Fi Protected Setup is complete. If this happens, please wait a short
while before trying to reconnect.
2
.
Wi-Fi Protected
Setup button
59