Advertisement
Available languages
Available languages
Step 4 — LUMINAIRE AIMING
Two sighting systems are provided for your convenience.
Use the sight system which is most easily accessed.
Optical Sight:
A. Rotate sight into vertical
position.
B. Align the reference mark
of top of reflector flange
with notch in sight for
proper aiming.
Base Sight
A. Rotate front and back
sight into vertical posi-
tion.
B. Align the two sighting
holes for proper aiming.
Step 6
Connect power cable to suitable supply in accord ance
with all applicable codes.
INSTALLATION CLEANING:
DO NOT CLEAN INTERNAL OPTICAL SYSTEM
The Ultra✭Sport floodlight has been specially recleaned at the
factory. Field cleaning of the internal optical system during
installation is not recommended.
EXTERNAL CLEANING
Initial cleaning of the outside of the glass lens may be
required to ensure optimum optical efficiency.
Clean front glass with a mild soap and water solution
rinse clean and wipe dry.
CLEANING INSTRUCTIONS AND CAUTIONS
CAUTION
Risk of burn
• Allow lamp/fixture to cool be-
fore handling
LAMP REPLACEMENT
A. Insert the lamp terminal into the
socket terminal (a) at both ends of the
lamp and tighten screws.
B. Slide the lamp ends into the sockets.
Step 5
After positioning luminaire, tighten all mounting
hardware.
Caution: Do not touch quartz tube lamp with bare
hands! If lamp is handled, finger prints, grease or oils
should be removed from the lamp with isopropyl alcohol.
This will remove material which cause whitish spotting
and premature lamp failure. Dry lamp carefully with cot-
ton or clean cloth.
PERIODIC CLEANING WHEN RELAMPING:
INTERNAL:
Should the internal reflector system require cleaning,
use only non-abrasive, neutral (pH 6-8) cleaner contain-
ing no chlorinated or aromatic hydrocarbons.
Rinse clean and wipe dry.
EXTERNAL:
Clean front glass with a mild soap and water solu-
tion, rinse clean and wipe dry.
NOTICE: Drain holes are provided in the proper loca-
tions for customary mounting positions. If floodlight is
to be aimed up above the horizontal, it is necessary to
punch out the two knockouts in the rear ballast cover
and plug the three front housing drain holes with a
suitable material such as silicone RTV.
C. Latch the lamp retainers (c).
D. Close and rebolt the relamping door. Tighten
bolts to 50 in. lbs. torque.
Advertisement
