Specifications - Makita LS1040 Instruction Manual

ENGLISH
1 Base
2 Hex bolt
3 Auxiliary plate
4 Nut
5 Bolt
6 Center cover
7 Socket wrench
8 Shaft lock
9 Loosen
10 Arrow
11 Blade case
12 Arrow
13 Saw blade
14 Spindle
15 Flange
16 Ring
17 Flange
18 Hex bolt
19 Tighten
20 Safety cover
21 Dust spout
22 Dust bag
23 Fastener
24 Lock-off button

SPECIFICATIONS

Model
Blade diameter .................................................................................................................................. 255 mm — 260 mm
Hole (arbor) diameter
For all countries other than European countries .......................................................................... 25.4 mm and 25 mm
For European countries ...................................................................................................................................... 30 mm
Max. cutting capacities (H x W) with blade 260 mm in diameter
Bevel angle
0°
45° (left)
–1
No load speed (min ) ............................................................................................................................................ 4,600
Dimensions (L x W x H) ..................................................................................................... 530 mm x 476 mm x 532 mm
Net weight ...............................................................................................................................................................11 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for accurate straight and miter cut-
ting in wood. With appropriate saw blades, aluminum can
also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
10
Explanation of general view
25 Switch trigger
26 Lever
27 Turn base
28 Kerf board
29 Sub-fence
30 Adjusting bolt
31 Pointer
32 Miter scale
33 Latch spring
34 Grip
35 Lever
36 Bevel scale
37 Pointer
38 Vise rod
39 Screws
40 Guide fence
41 Vise arm
42 Clamp screw
43 Support
44 Knob
45 Projection
46 Holder
47 Screw
48 Holder assembly
Miter angle
69 mm x 135 mm
35 mm x 135 mm
0°
93 mm x 95 mm
53 mm x 95 mm
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.30 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Safety hints
For your own safety, please refer to enclosed safety
instructions.
49 Screw
50 Rod 12
51 Cutting line
52 Groove
53 Vise
54 Spacer block
55 Aluminum extrusion
56 Spacer block
57 Over 10 mm
58 Over 460 mm
59 Hole
60 Set plate
61 Screw
62 Triangular rule
63 Hex bolts
64 Arm
65 Hex bolt (A)
66 Top surface of turn base
67 Arm holder
68 Hex bolt (B)
69 Limit mark
70 Screwdriver
71 Brush holder cap
45° (left and right)
93 mm x 67 mm
69 mm x 95 mm
49 mm x 67 mm
35 mm x 94 mm
LS1040