Table of Contents
Advertisement
1
display assembly
Replacing the Display Assembly
1. Follow the instructions in
Before You
2. Place the display assembly in position and replace the two screws that secure the display assembly to the computer base.
3. Route the display cable and Mini-Card antenna cables through the routing guides.
4. Connect the display cable to the connector on the system board.
5. Connect the Mini-Card antenna cables to the Mini-Card.
6. Replace the hinge cover. See
7. Replace the USB board. See "Replacing the USB Board" on page 48.
8. Replace the optical drive. See
9. Follow the instructions from
10. Replace the battery. See
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel
Removing the Display Bezel
1. Follow the instructions in
Before You
2. Remove the display assembly. See
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the display bezel.
3. Using your fingertips, carefully pry up the inside edge of the display bezel.
4. Remove the display bezel.
2
screws (2)
Begin.
Replacing the Hinge
Cover.
Replacing the Optical
Drive.
step 3
to
step 7
in
Replacing the Palm-Rest
Battery.
Begin.
Removing the Display
Assembly.
Assembly.
Advertisement
Table of Contents
