Advertisement

Car2U
Overhead Door

Setting the Car2U to Factory Default settings

The default setting for the Car2U system is:
Button 1= Overhead Door
Button 2= LiftMaster
Button 3= Wayne Dalton
1.
Press and hold buttons 1 and 3 for twenty seconds or until all three
LED's begin to flash.
2.
Release both buttons. The Car2U system is now set to the Factory
Default settings.

Changing a button to Overhead Door

1.
Press and hold buttons 1 and 3 for one second and release– all
three LED's will light solid RED.
2.
Press and Hold the button (2 or 3) you want to change to Overhead
Door – the corresponding LED will flash. While continuing to hold the
button you want to change, Press and release button 1. Press and
release button 1 again.
3.
Release the button (2 or 3) you were holding in Step 2 and wait for
the LED to stop flashing. This button is now set for Overhead Door.
NOTE: Repeat this procedure for the remaining button to change to
Overhead Door if so desired.
®
System Programming for
®
Garage Door Openers
®
manufactured openers
®
manufactured openers
®
manufactured openers
1
©2013 Overhead Door Corporation.
3
2
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the car2u and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Overhead door car2u

  • Page 1 Press and hold buttons 1 and 3 for twenty seconds or until all three LED’s begin to flash. Release both buttons. The Car2U system is now set to the Factory Default settings. Changing a button to Overhead Door Press and hold buttons 1 and 3 for one second and release–...
  • Page 2 PRGM is on – release the button. The long LED will flash purple. Press the desired Car2U button for one second and release. Press that same button again for one second and release. The round and long LED will both turn blue and then turn off.
  • Page 3 LED will begin PRGM flashing. Press the desired Car2U button for one second and release. Press the same button again and release. The long LED will flash blue and then turn off. Pressing the Car2U button again will cause the garage door to move.
  • Page 4 Both the long and round LEDs flash purple. Press the desired Car2U button for one second and release. Both the long and round LEDs go solid purple. Press the desired Car2U button (again) for one second and release.
  • Page 5 Press the desired Car2U button one time. The red LED will stop blinking and stay on. Press the desired Car2U button one more time. The red LED will go out. Pressing the Car2U button again will cause the garage door to move.
  • Page 6 Press the desired Car2U button one time. The red LED will stop blinking and stay on. Press the desired Car2U button one more time. The red LED will go out. Pressing the Car2U button again will cause the garage door to move.

Table of Contents