i
Copyright
The entire contents of this manual and its appendices, including any future
updates
and
C&C Technologies, Inc. at all times. The contents must not, whether in its
original form or modified, be wholly or partly copied or reproduced, nor
used for any other purpose than the subject of this manual.
ii
Disclaimer
While reasonable care has been exercised in the preparation of this manual,
C&C Technologies, Inc. shall incur no liability whatsoever based on the
contents or lack of contents in the manual.
iii
Caution
No single navigation aid should ever be relied upon as the exclusive means
for navigating a vessel. The navigator is responsible for checking all aids
available to confirm his position. Electronic aids are intended to assist, not
replace, the navigator.
iv
Software
This manual reflects the capabilities of R4 Navigation Display software
version 5.0.94
v
Installation Manual Part Number and Revision
Part number SAA7000 109-142, revision G2.
This manual is a replacement for the earlier manual SAA7000 109-142 rev G.
vi
Safety Instructions
Note the following compass safe distances:
Equipment
R4 Display
R4 Navigation Sensor
(GPS and DGPS)
vii
Contact Information
For installation, service and technical support please contact C-Nav Support:
cnav.support@cnavgps.com, or by phone: +1 (337) 210-0000
modifications,
shall remain
Standard magnetic
compass
0.6 m
0.6 m
the
property
of
Steering magnetic
compass
0.3 m
0.4 m
Need help?
Do you have a question about the 1000 R4 and is the answer not in the manual?