First Installation & Connections - Goldmund Mimesis 16.8 User Manual

NOTE
In all system and specially in HDMI wiring, to
guarantee the HD signal throughout the full
system, Goldmund recommends to perform all
the wiring when all units are turn off and
successively turn on the units according to the
following combination: screen,
processor or preamplifier and finally the player.
1 SETTING UP THE MIMESIS 16.8 (Ctd.)
1.5 FIRST INSTALLATION & CONNECTIONS
POWER CONNECTION
Plug the AC power cord to the power supply and into a wall socket.
The acoustic processor is and remains on power as soon as the power switch located on
the back panel is turned on. For best sonic results, Goldmund recommends to leave the unit
powered on permanently.
When the machine is in standby mode, the front panel Led controls are off except the red
STB Led, but the circuitry remains connected as long as the power supply switch is not
turned off. The standby mode is controlled by the remote.
COMPUTER CONFIGURATION
Consult your official Goldmund distributor for configuration.
acoustic
SOURCES CONNECTION
Connect the analog sources or tape machines to the back panel analog inputs and the
digital sources to the digital inputs of the Goldmund Mimesis 16.8, using the RCA input
connectors for analog sources and the choice of RCA for SPDIF, XLR for AES-EBU or
optical for the digital sources.
The inputs are numbered on the back panel.
Digital inputs are numbered from 1 to 10. Digital input 3 and 4 offer two different connector
standards. Only one must be used per input, both work equally well. Digital input 7 to 10 are
reserved for HDMI connection.
GOLDMUND MIMESIS 16.8 - UNIVERSAL ACCOUSTIC PROCESSOR - 6