Advertisement
5. If desired, select an adjustable comb (attachments 1 and 2). The adjustable cutting
combs can have the cutting length adjusted by sliding out the bottom of the adjustable
comb. The cutting lengths are 2mm, 4mm, 6mm, 8mm
(attachment 1) and 10mm, 12mm, 14mm and 16mm (attachment 2),
depending on which adjustable comb is selected. The length selected is shown in the
circle.
6. Make sure head 1 is attached to the clipper, and clip on the adjustable comb, once
the
desired length has been selected.
Switch on by pushing the on/off switch upwards.
7. For even cutting allow the comb to cut its way through the hair. Do not force it
through quickly. Always remember to comb the hair frequently to remove trimmed
hair and to check for uneven strands. Switch off when not in use by pushing the on/off
switch downwards.
8. Attachment 3 can also be used for blending.
USING THE BEARD TRIMMER
1. To trim facial hair, attach head number 2. If desired, use attachments 1, 2 or 3
as well. The interchangeable heads can be changed by pushing the release
buttons on each side of the clipper.
USING THE ETCHER AND DEFINER
2. For etching and defining attach head number 3. This head can be used for
facial hair and head hair.
3.
USING THE NASAL TRIMMER
4. For nasal trimming attach head number 4. Lightly press the nasal trimmer
against the wall inside the nose.
5.
USING THE SHAVER
4. For shaving facial hair attach head number 5. Gently press the foil shaver head
against the chin to remove hair. If the clipper becomes blocked by excess hair while
cutting, switch the clipper off. If operating from the mains, unplug. Remove the
adjustable comb and lightly brush hair from the clipper using the cleaning brush
provided. Alternatively take off the shaver head from the clipper unit, and wash the
shaver head ONLY under running tap water . Then dry and re-attach to the clipper for
further use. If the blades are moving slowly or do not move they may be dirty or
clogged. Please refer to the Cleaning and Maintenance section.
How to use the attachment combs
There are 3 attachments provided
-
Cutting comb with 2,4,6,8mm cutting length for hair trimmer and beard
trimmer
-
Styling comb with 10,12,14,16mm cutting comb for hair trimmer only
Advertisement
