NAD T175 Owner's Manual page 11

13 HDMI (HDMI 1-4, HDMI MONITOR OUT): Connect HDMI inputs to
the HDMI OUT connectors of source components such as DVD player or
HDTV satellite/cable box. Connect the HDMI Monitor OUT to a HDTV or
projector with HDMI input.
WARNING
Before connecting and disconnecting any HDMI cables, both the T 175
and the ancillary source must be powered OFF and unplugged from the
AC outlet. Failure to observe this practice may cause permanent damage
to all equipment connected via HDMI sockets.
14 DIGITAL AUDIO IN (OPTICAL 1-3, COAXIAL 1-3): Connect to the
optical or coaxial S/PDIF-format digital output of sources such as CD or
DVD players, HDTV or satellite tuners and other components. Coaxial
and Optical digital input association is configurable via the Setup Menu.
DIGITAL AUDIO OUT (OPTICAL, COAXIAL): Connect the optical or
coaxial digital OUT port to the corresponding S/PDIF digital input of a
compatible device such as CD recorders, receivers, computer soundcard
or other digital processors.
15 COMPONENT VIDEO 1-3 IN, COMPONENT VIDEO OUT: Connect
the Component Video IN 1-3 inputs to Component Video outputs
from compatible source components, typically a DVD player and
terrestrial or satellite HDTV tuner. Connect Component Video OUT to
the Component Video input of a compatible video monitor/TV. Be
sure to observe consistency in connecting the Y/Pb/Pr jacks to the
corresponding sources/inputs. The routing of the component video
inputs is fully configurable via the Setup Menu.
The T 175's component video inputs and outputs are fully wideband
and compatible with allowable HDTV formats.
IDENTIFICATION OF CONTROLS
16 AC POWER INLET: Connect to the supplied IEC-standard removable
AC power cord or a compatible cord.
17 SWITCHED AC OUTLET: This convenience outlet can supply switched
power to another component or accessory. It is powered ON and OFF
by the front panel POWER SWITCH or by the HTRC 1's ON and OFF keys.
The total draw of all devices connected to this jack must not exceed 120
watts (North America version) or 115 watts (Europe version).
18 POWER: The POWER switch supplies the master AC mains power for
the T 175. When this switch is at ON position, the T 175 is in standby
mode as shown by the amber status condition of the standby LED. If
you intend not to use the T 175 for long periods of time (such as when
on vacation), switch the POWER switch to the OFF position. When the
POWER switch is at OFF position, the front panel power button, HTRC 1
remote control or ZR 4 cannot activate the T 175.
REAR PANEL
11