Lindy 32540 User Manual page 2

Manual
Introduction
Thank you for purchasing the LINDY VGA & Audio Cat.5e Extender. This device allows a VGA video signal and
Audio (mono) to be transmitted up to a distance of 300m using high quality Cat.5e solid core cable. An optional
skew compensation unit (like LINDY No. 32766) can be used to correct colour shadows on the display caused by
different lengths of RGB signal transmission over the twisted pairs in the Cat.5e cable.
Package Contents
VGA & Audio Cat. 5e Extender – Transmitter unit
VGA & Audio Cat. 5e Extender – Receiver unit
2 x 5V ~2A DC Multi Country PSU
This manual
Features
Supports display resolutions up to 1920x1200@60Hz or 1600x1200@60hz or
Supports Mono audio signals (left and right channels are combined)
Allows video & audio signals to be extended up to a maximum distance of 300m via high quality solid core
Cat.5e cables. A skew compensation unit like LINDY no. 32766 may be required to get the best image quality.
Gain and Peak adjustment option on the receiver unit.
Supports local monitor and speakers out ports on the transmitter unit
Installation and Operation
Please switch off all the devices involved in the installation before starting to make any connection.
NOTE: All cables listed in the following procedure can be found and bought directly on the LINDY Website
(www.lindy.com)
NOTE: Please use short VGA and audio cables (i.e. 1m) to ensure the best results
For the installation please use the following steps:
1) Connect the remote display / projector and speakers to the receiver unit with a standard VGA (male /
male) cable and (if needed) a standard audio cable with 3.5mm Stereo jack connectors.
2) Connect the RJ45 connector of the Cat.5e cable to the receiver unit.
3) Connect the other RJ45 connector of the Cat.5e cable to the transmitter unit.
4) Connect the local display / projector and speakers to the OUTPUT ports on transmitter unit using a
standard VGA (male / male) cable and a standard audio cable with 3.5mm Stereo Jack connectors.
5) Connect the VGA video source and audio source to the related INPUT ports on the transmitter unit
using a standard VGA (male / male) cable and (if needed) a standard audio cable with 3.5mm Stereo
jack connectors.
6) Connect the Power Supply Units to the DC power ports on both the transmitter and receiver unit and
then to the mains power socket.
7) Switch on all the other devices.
1
English
2048x1536@60Hz