Hoover C1633 Operating, And Servicing Instructions page 8

Lubrication
The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The
addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings.
The agitator brush roll is equipped with two ball bearings that should be lubricated periodically by a
Hoover Sales and Service Center or an Authorized Hoover Warranty Service Dealer.
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Sales and
Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:
• checking the Yellow Pages under "Vacuum Cleaners - Household"
• checking the Service section of Hoover on-line at hoover.com
• calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only).
Do not send your cleaner to Hoover in Glenwillow, Ohio for service, this will only result in delay.
If further assistance is needed, contact the Hoover Consumer Response Center, 1-800-263-6376,
Mon-Fri 8 -7 .
am pm est
In Canada: Carson Building; 100 Carson St.; Etobicoke, ON; M8W3R9; 1-800-263-6376, Mon-Fri 8
Always identify your cleaner by the complete model number when requesting information or ordering parts.
(The model number appears on the back of the cleaner.)
3. TROUBLESHOOTING
If a minor problem develops, it usually can be remedied quite easily when the cause is identified by
using the check list below.
PROBLEM POSSIBLE REASON
Cleaner won't run 1. Power cord not firmly plugged
into outlet.
2. No voltage in wall plug.
3. Blown fuse or tripped breaker.
Cleaner won't pick 1. Dirt cup full.
up or low suction
2. Agitator Brushes worn.
3. Broken or worn belt.
4. Carpet height setting is incorrect.
5. Bag dirty.
Cleaner is hard 1. Carpet height setting is incorrect.
to push
2. Belt on backwards.
-7
am
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Check fuse or breaker in home. Replace fuse/
reset breaker.
1. Empty dirt cup.
2. Replace Agitator Brushes.
3. Replace belt.
4. Set carpet height adjustment to appropriate
setting for carpet being cleaned.
5. Unhook and shake bag.
1. Set carpet height adjustment to appropriate
setting for carpet being cleaned.
2. Position belt correctly.
8
.
pm est