SAGEMCOM DTR 6400T User Manual page 16

DTR67_ EN.book Page 12 Mardi, 20. avril 2010 2:46 14
7-2-2 User preferences
In the USER SETTINGS menu, select USER PREFERENCES.
- Banner time-out: you can set the display time of the information banner.
- Network monitoring: you can activate network monitoring. If activated, you will be informed of any
new channel or service when it is available.
- Volume bar time-out: you can set the display time of the volume indicator.
- User country: displays your geographical location.
If you want to change country, please perform a reset to default settings
(see "Return to default factory settings", page 15).
If you make a wrong selection, some services or channels may become
unavailable.
- Recording Type (depending on software version): you can specify the mode to be applied by default
for recordings that you programme via the electronic programme guide: Programme or Timer mode.
If the recording type choice does not appear among the user preferences, it
means that this mode is not available for your country. Only the fixed Timer
recording mode is available to you (see "Recording modes: Timer or
Programme", page 27).
- EPG record margin settings (Timer mode): you can programme recording margins which will be
automatically added to the recordings carried out via the electronic programme guide, in Timer mode.
You can thus programme the receiver so that it starts to record a programme before its announced
start time, and stops after its announced end time.
- Sleep Timer: you can set the receiver to automatically switch to standby mode at a specific time.
When this is set, the receiver will be put automatically into standby mode at the specified time (24H
format).
- 12 -