Table of Contents
Advertisement
IRQ3 ~ IRQ15 enable or disable the monitoring of the specified
IRQ line. If set to [Enabled], the activity of the specified IRQ line
will prevent the system from entering power saving modes or
awaken it from power saving modes.
sources allocated to I/O devices. When an I/O device needs
to gain attention of the operating system, it signals this by
causing an IRQ to occur. After receiving the signal, when the
operating system is ready, the system will interrupt itself and
perform the service required by the I/O device.
Power Status LED
This item configures how the system uses power LED on the case to indicate
the sleep/suspend state. Available options are:
Single
Dual
Note: IRQ (Interrupt Request) lines are system re-
The Power LED turns off during the sleep/sus
pend mode.
The Power LED changes its color to indicate the
suspend state.
3-23
AWARD BIOS Setup
Advertisement
Table of Contents
