Firmware Renewal Mode - Emerson 6513DE Service Manual

1. Turn the power on and press [SELECT] button on
the remote control unit to put the DVD player into
DVD mode. Then remove the disc on the tray.
(It is possible to move to F/W version up mode only
when the DVD player in DVD mode with the tray
opened.)
2. To put the DVD player into F/W version up mode,
press [9], [8], [7], [6], and [SEARCH MODE] but-
tons on the remote control unit in that order.
Fig. a appears on the screen.
" ******* " differ depending on the models.
F/W Version Up Mode
Please insert a DISC
for F/W Version Up.
Fig. a Version Up Mode Screen
The DVD player can also enter the version up
mode with the tray open. In this case, Fig. a will be
shown on the screen while the tray is open.
3. Load the disc for version up.
4. The DVD player enters the F/W version up mode
automatically. Fig. c appears on the screen. If you
enter the F/W for different models, "Disc Error" will
appear on the screen, then the tray will open auto-
matically.
" ******* " differ depending on the models.
F/W Version Up Mode
VERSION : X5****_****.ab5
Reading...(*2)
Fig. c Programming Mode Screen
The appearance shown in (*2) of Fig. c is
described as follows:
No. Appearance
1 Reading... Sending files into the memory
2 Erasing... Erasing previous version data
3 Programming... Writing new version data

FIRMWARE RENEWAL MODE

Model No : *******
VERSION : *.**
EXIT: SELECT
Model No : *******
VERSION : *.**
State
5. After programming is finished, the tray opens auto-
matically. Fig. e appears on the screen and the
checksum in (*3) of Fig. e.
" ******* " differ depending on the models.
F/W Version Up Mode
VERSION : X5****_****.ab5
Completed
SUM : 7ABC (*3)
Fig. e Completed Program Mode Screen
At this time, no buttons are available.
6. Remove the disc on the tray.
7. Press [CH UP/DOWN] button on the unit to go to
TV mode, or press [POWER] button on the unit to
turn the power off.
8. Press [SELECT] or [DVD PLAY] button on the unit
to put the DVD player into DVD mode again.
9. Press [1], [2], [3], [4], and [DISPLAY] buttons on the
remote control unit in that order.
Fig. g appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR
10.Press [CLEAR] button on the remote control unit.
Fig. h appears on the screen.
" ******* " differ depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR
When "OK" appears on the screen, the factory
default will be set. Then the firmware renewal mode
is complete.
11.To exit this mode, press [CH UP/DOWN] or
[SELECT] button to go to TV mode, or press
[POWER] button to turn the power off.
1-7-1
Model No : *******
VERSION : *.**
EXIT: SELECT
Fig. g
EXIT: SELECT
Fig. h
T9000TEST