Advertisement
1. Fill Carts if Needed - If you purchased your system prefilled, then go to Step 2.
If the cartridges are empty (no ink in tubes), then vacuum fill the cartridges with
the ink that came with the system or the ink of your choice. Follow the instructions
that came with the MIS Vacuum Pump. When this is complete, go to Step 2.
2. Free Carriage - On the printer, push the Ink button (this is the one that has ink
drop icon on it) to move the cartridges to the Replace position. While in this
position, pull the power plug out of the wall.
3. Remove the Epson cartridges and PARTIALLY install the CFS cartridges. Do not
push the cartridges all the way down. We do not want the seals on the bottom to be
punctured until the tubes have been installed in the bottles.
4. Install the Middle Bracket on the inside surface of the printer housing. The
opening on the bracket should point up. Place it as high as possible. Looking from
the back of the printer, the right edge of the clear bracket should be about one
half inch to the left of center of the printer. See photo below.
The tubing is marked with two vertical black lines. This is where the tube goes into
the bracket. Use some alcohol on the tubes to get them inserted into the clear
bracket.
If you tube does not have the black marks on it, then put marks at 8 3/8 and 9 3/8
from the edge of the black cartridge.
Install the Velcro strip over the ribs on the inside of the housing as shown in the
photo to protect the tubes when they rub or touch the housing.
S a v e
M o n e y
MIS Associates Inc
http://www.inksupply.com
a n d
I m p r o v e
2901 Auburn Rd
Fax: 248-289-6013
Y o u r
Auburn Hills, MI 48326
Email: sales@inksupply.com
P r i n t i n g
800-445-8296
Advertisement
