General Safety Information - Panasonic FV-08-11VFM5 Installation Instructions Manual

GENERAL SAFETY INFORMATION CONTINUED
WARNING
These models are UL listed for tub and shower enclosures.
Canada only: Not to be installed in a ceiling thermally insulated to a value greater than R40.
Do not disassemble the unit for reconstruction. It may cause fire or electric shock.
A statement to the effect that when the product is to no longer be used, it must not be left
in place but remove, to prevent it from possibly falling.
Ceiling joist must be subjected to static load more than five times the weight of the product.
Do not install with a method which is not approved in the instructions.
Do not use these fans with any solid-state speed control device. Solid state controls may cause
harmonic distortion which can cause motor humming noise.
These products must be properly grounded.
CAUTION
Do not install these ventilating fans where interior room temperature
may exceed 104°F(40°C).
Make sure that the electric service supply voltage is AC 120V, 60Hz.
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).
Always disconnect the power source before working on or near the fan,
motor or junction box.
Protect the supply wiring from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
Do not kink the supply wiring.
Provide make up air for proper ventilation.
For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
Do not install the unit where ducts are configured as shown
in Fig.A.
Not for use in cooking area. (Fig.B)
The special-purpose or dedicated parts, such as mounting
fixtures, must be used if such parts are provided.
Extreme
Prohibited bending
Bend
Prohibited repeatedly
Duct
Prohibited narrow
Fan body
Adaptor
Prohibited
Bend near
adaptor
(Cooking area)
Do not install above or
inside this area
Floor
Cooking
equipment
Fig. B
3