Omega OF916FKXP Instruction Manual page 20

CLEANING THE APPLIANCE
Before cleaning the appliance, it should be disconnected from the power supply and turned off the main gas feeder
valve.
Cleaning the work surface
Periodically clean the burner parts and trivets as listed below. Note that all parts must be thoroughly rinsed and dried
before being replaced.
Any liquid that overflows from pots must always be removed using a rag.
If it becomes difficult to open or close a valve, do not force it, but immediately contact the omega service department.
Cleaning the enamelled parts
The trivets and burner covers are cast iron with an enamel coating. To maintain the original features of the
enamelled parts they should be cleaned frequently with soapy water. Never use abrasive powders. Do note leave
acidic or alkaline substances on the enamelled parts (vinegar, lemon juice, salt, tomato sauce, etc.) and do not
wash the enamelled parts while they are still hot.
Cleaning the STAINLESS steel parts
Clean the parts with soapy water and then dry them with a soft cloth. The shine is maintained by periodically
using special products that generally are found in the market. Never use abrasive powders.
Cleaning the burner bodies
The aluminium burner bodies sit on the burner bases. Remove from the base and wash them with soapy water. Rinse
and dry, and check that all holes and slots are fully cleaned. Replace on the burner bases, taking care that they are
positioned and orientated correctly.
Cleaning the inside of the oven
To thoroughly clean the inside of the oven, it is recommended that the door be removed first. First lock the hinge in
place with the nail supplied (01-02). With the hinges fixed, grab both sides of the door and slowly work the door off
the hinges towards you. Once fully removed, place in a safe position until it is time to fix back in place (in the opposite
order). The internal rack guides can also be temporarily removed by undoing the screws holding them in place and
lifting out.
20