How To Apply The Arm Cuff - Omron HEM-711AC Instruction Manual

HOW TO APPLY THE ARM CUFF

1. If the cuff is assembled correctly, the
hook material will be on the outside
of the cuff loop and the metal D-ring
will not touch your skin.
2. If the cuff is not assembled, pass
the end of the cuff furthest from
the tubing through the metal D-ring
to form a loop. The smooth cloth
should be on the inside of the cuff loop.
3. Sit in a chair with your feet flat
on the floor and place your arm
on a table so that the cuff is at the
same level as your heart.
4. Put your arm through the cuff
loop. The bottom of the cuff should
be approximately 1/2" above
the elbow. The Green Marker
on the cuff should lie over the
brachial artery on the inside
of the arm. Tube should
run down center of arm
approximately even
with middle finger.
Pile Side Material
Bottom Edge 1/2 Inch
Green Marker
29
Sewn Hook Material
D-Ring
Cuff Tube