Using The Controls - Hamilton Beach HBH850 Operation Manual

Using the Controls

There are several blending options available, including AUTOBLEND, JUMP cycles, HIGH, or LOW cycles,
each with adjustable time settings. You may also store favorite settings for later use with the A, B, C, or D
buttons. For quick blending or to "freshen up" a beverage, use the PULSE button.
AUTOBLEND
START, SCROLL TO SET
JUMP 4–12 sec
START, SCROLL TO SET
JUMP
LOW/HIGH 12 sec
HIGH
LOW
PULSE
PULSE
A
A B C D
D
6
0
START
START
START
0 sec
START
STOP
MORE
This is the default screen for the blender or if AUTOBLEND
is pressed . On setting 0, the blender senses when the drink
is finished and stops automatically. Press L or M button to
change to AUTOBLEND 1, 2, or 3 to add additional time.
Press START to run cycle.
Pressing JUMP displays the default jump cycle times (4
seconds at low, then 12 seconds at high). Press L or M
button to change the cycle length. Press START to
run cycle.
Pressing HIGH or LOW displays current run time for that
speed. Press L or M button to change cycle length. Press
START to run cycle.
Press and hold the PULSE button to run blender at HIGH
speed. Release to stop blender. Display will indicate
length of time the button is held.
These buttons allow you to save your favorite settings.
Select A, B, C, or D and press START to run cycle stored
in that location. To store a new cycle, adjust the speed and
time settings, then press and hold A, B, C, or D button for
3 seconds to save it to that location. A confirmation
message will show when cycle is SAVED.
NOTE: Saving a new cycle to a location will overwrite any
existing cycle in that location.
Pressing STOP will stop any cycle currently in use.
Pressing the MORE button displays cycle count screens
and other diagnostic information.