WinFast ck804k8ma series Manual page 26

S-ATA Connectors: SATA0, SATA1, SATA2, SATA3
The Serial ATA connectors are used to connect
the Serial ATA devices to the motherboard. These
connectors support the thin Serial ATA cables for
primary internal storage devices. The current
Serial ATA interface allows up to 150MB/s data
transfer rate.
Front Audio Connector: F_AUDIO
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the
front panel of the chassis (using the Front
Audio), then the Line Out (Rear Audio) on the
rear panel will not work. If you do not want to
use the Front Audio, pin 5 and 6, pin 9 and 10
must be short, and then the signal will be
sent to the rear audio port.
Audio Connectors: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN is Sony standard CD audio
connectors, to receive audio input from the CD-ROM,
attach its audio connector to the CD_IN/AUX_IN au-
dio connectors on the motherboard.
Speaker Connector: SPEAKER
The speaker connector is used to connect
speaker of the chassis.
18
CK804K8MA-manual-V1.0-111704.p65
Chapter 2 Installation Instructions
CK804K8MA Series User Manual
18
GND
RX+
RX-
GND
TX-
TX+
GND
SATA0/1/2/3
1 2
MIC_IN
MIC_PWR
AUD_OUT_R
NC
AUD_OUT_L
9 10
F_AUDIO
CD_L
GND
CD_R
AUX_R
GND
AUX_L
Empty
+5V NC SPEAKER
SPEAKER
2004-11-19, 14:51
MIC_GND
+5VAC
AUD_RET_R
EMPTY
AUD_RET_L
CD_IN
AUX_IN