Front Panel; Rear Panel; Connecting Your System - Gi Mini User Manual

English
Play
To play the MP3, JPEG or recording file.
Stop
To stop MP3/JPEG player, recording file , Time Shift, or playback.
PAUSE
Used to select the freeze function.
Press once to freeze the screen picture.
Record
To start recording.
Fast Backward
To start Fast Backward function.
Fast Forward
To start Fast Forward function .
Slow Backward
To start Slow Backward function .
Slow Forward
To start Slow Forward function

5. Front panel

Remote Sensor: Detects infrared signal from remote control unit
POWER Indicator: When the receiver is on and at standby mode, it is show a red light. Or the
When power is on at working mode it is show green light.
Signal Indicator: When receiving signal is strong, the signal indicator is lighted.
Card Slot: One slot CA Interface for Conax.
USB: USB 2.0 Host, connect to USB hard disk, or flash disk

6. Rear Panel

Please refer to the diagram above for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and checked.
Your configuration can vary depending on model
DC 12V: Connect the supplied external power supply like.
LNB IN 13/18V 500mA MAX: This port is to connect the coaxial cable from LNB of your Dish.
AV OUT : This port is used to connect the television with a RCA AV connector line.
HDMI: Audio and Video output socket for TV set with HDMI Input Jack only.
RS 232 : This port is used to connect your receiver and computer through a serial cable.
USB: USB 2.0 Host, connect to USB hard disk, or flash disk
ETHERENT: This is used to connect internet.
IR IN: Remote infrared port connect remote control unit through a RCU infrared adapter. You can set
the receiver to appropriate place (behind TV for ex.).

7. Connecting Your System

There are two ways to connect the receiver to your existing TV system. We recommend using one of
the following cases for the best result:
1. If you have a high definition television set, you should use a HDMI cable for best result, Plug one
end of the cable into the HDMI socket on the receiver, and the other end into the matching socket on
.
6