Installation And Setup Procedures; Unpacking; Handling Precautions; Inspection Of Shipping Container - Western Digital WD15NPVX Technical Reference Manual

Installation and Setup Procedures

5.0 I
NSTALLATION AND
Hard drives are precision instruments that must be handled with care to prevent damage. It is important to
understand that drives are typically damaged due to electrostatic discharge (ESD), pressing on the top cover,
rough handling, or shock and vibration. Also refer to the WD 2.5-inch Hard Drive Handling poster (part
number 2378-701047) for details on drive handling.
Important: If your system does not support hot plugging (see "Hot Plug Support" on page 17), it must
5.1

Unpacking

5.1.1
WD products are designed to withstand normal handling during unpacking and installation. Take care
to avoid excessive mechanical shock, pressing on the top cover, or electrostatic discharge (ESD) which
can permanently damage the hard drive and void the warranty. Hard drives are typically damaged
because of ESD, rough handling, or shock and vibration.
Figure 5-1. Drive Handling Precautions
Hard drives are delicate, precision instruments and should be handled with care at all times.
Hard drives are typically damaged by rough handling, shock, vibration, and electrostatic discharge (ESD).
Handle the Drive ONLY by its Sides
To avoid ESD problems, wear a properly grounded wrist strap when handling the hard drive. Articles
of clothing generate static electricity. Do not allow clothing to come in direct contact with the hard
drive or circuit board components.
When the drive is not in its shipping container or installed in its proper host enclosure, it must remain
in the antistatic bag. To prevent damage, do not unpack your drive until you are ready to install it.
CAUTION:To avoid damage to internal drive components, do not apply a load greater than
36
S P
ETUP ROCEDURES
be turned off and unplugged before installing your hard drive.

Handling Precautions

DO NOT Press on the Top Cover of the Drive
2.6 lbf to a circular 10 mm diameter area anywhere on the top cover. Chassis
design should allow for sufficient clearance and support to prevent loads from
being transferred to the drive top cover.
RELEASED 5/2/13 (WD CONFIDENTIAL)
WD Green MB500M-6Gb
2679-771422-A00