Download  Print this page

Canceling The Demo Mode; Preparing The Card Remote Commander; Setting The Clock; Detaching The Front Panel - Sony MEX-BT2800 Operating Instructions Manual

Bluetooth audio system.
Hide thumbs

Advertisement

Canceling the DEMO mode

You can cancel the demonstration display which
appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "DEMO" appears.
3
Rotate the control dial to select
"DEMO-OFF."
4
Press and hold the select button.
The setup is complete and the display returns
to normal reception/play mode.
Preparing the card remote
commander
Remove the insulation film.
Tip
For how to replace the battery, see page 25.

Setting the clock

The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press (SEEK) +.
The hour indication flashes.
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press (SEEK)
–/+.
5
After setting the minute, press the
select button.
The setup is complete and the clock starts.
To display the clock, press (DSPL/SCRL). Press
(DSPL/SCRL) again to return to the previous
display.
Tip
You can set the clock automatically with the RDS
feature (page 16).

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press and hold (SOURCE/OFF).
The unit is turned off.
2
Press
, then pull it off towards you.
(SOURCE/OFF)
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.

Attaching the front panel

Engage part A of the front panel with part B of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
A
B
7

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: