Mounting Of Protector - Makita EBH341U Original Instruction Manual

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector
combinations as indicated in the table must be used.
Be sure to use genuine MAKITA metal blades or
nylon cutting head.
– The metal blade must be well polished, free of cracks or
breakage. If the metal blade hits against a stone during operation,
stop the engine and check the blade immediately.
– Resharpening or replace the metal blade every three hours of
operation.
– If the nylon cutting head hits against a stone during operation,
stop the engine and check the nylon cutting head immediately.
CAUTION: The appropriate protector must always be installed, for
your own safety and in order to comply with accident-
prevention regulations.
Operation of the equipment without the guard being in
place is not permitted.
The outside diameter of the cutter blade must be
255 mm (10"). Cutter blades with outside diameter of
305 mm or 12 inches can be used only for those with
three blades.
Use 200 mm saw-blade protector only when using
200 mm saw-blade.
– In use of the metal blade, fix the protector (3) to the clamp (2) with two bolts
(1).
NOTE: Tighten the right and left bolts evenly so that the gap between the clamp
(2) and the protector (3) will be constant.
Otherwise, the protector sometimes may not function as specified.
Cutter blade
Nylon cutting head
200 mm saw blade
10
Protector for cutter blades
Protector for
nylon cutting head
Protector for
200 mm saw blade
(1)
(2)
(3)
(1)
(3)
(2)