Dust Cup - Makita DHR242 Instruction Manual

1
2
001296
Insert the bit into the tool. Turn the bit and push it in until it
engages.
2
1
012624
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
2
1
012625
Bit angle
(when chipping, scaling or demolishing)
012632
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
1. Bit
2. Chuck cover
1. Action mode
changing knob
2. O symbol
2
1
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
012633
Depth gauge
1
3
2
012626
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing.

Dust cup

012636
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006386
8
symbol. Then make sure that the
1. Hole
2. Depth gauge
3. Loosen
4. Tighten
4
1. Dust cup
1
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")