Table of Contents
Advertisement
schwa-medico Operating Instruction - EMP 2 PRO
Locking the programmme
Choose the programme desired for the patient using the
key (please refer
to section entitled "Description of programmes"). Lock the device by then pres-
sing the
key on the left and also the
key. A key appears in the upper
right-hand corner of the display. All device functions apart from stimulation
with the selected programme are now no longer available. Use the same key
combination to unlock the device. A locked device cannot be started in the
editing mode.
Locking the intensity
Choose the programme desired for the patient using the key (please refer to
section entitled "Description of the programmes"). The EMP 2 PRO will be lo-
cked automatically after 10 sec. without increasing or decreasing the intensity.
On the display in the right corner the "P" symbol will be showed. To unlock the
EMP 2 PRO you have to decrease the intensity.
Activating the editing mode
Please switch on the device while pressing the
key. An "E" on the right-
hand side of the display indicates the editing mode. Then use the key to select
the standard or user programme (Fig. 6) that you wish to edit.
The key is then used to start editing the currently active standard or user pro-
gramme. This is shown by the fact that the "P" or "U" symbol before the pro-
gramme number changes to an"E".
Editing standard or
user programmes
The parameters of each programme are used as the starting value. Press the
key to jump to the next parameter or to save the values.
Use the
key to interrupt the editing process at any time without saving the
altered parameters.
Various parameters may be processed, depending on the type of programme. If
not indicated otherwise, the frequency and the pulse width apply for both chan-
nels. Use the modification keys to adjust the values. If you keep the keys pressed
down, counting up or down of the parameter is automatically continued.
Advertisement
Table of Contents
