Mounting The Camera On A Wall Safely; Night Vision; Using The Zoom / Pan & Tilt Functions; Adjusting The Volume - Lenovo ayden User Manual

SETUP

Mounting the Camera on a Wall Safely

Before drilling the holes, it is important to check the reception and camera positioning in
the intended location on the wall. Ensure you are hanging the camera no less than 3 feet
away from baby's crib.
Note: Baby monitors with power cords should never be hung on or near the crib
as it is a strangulation hazard. Power cords should be kept no less than 3 feet
away from the crib and the baby's reach at all times.
1. Pre-drill two holes in the wall using a 3/16", 4.8mm drill bit.
2. Insert wall anchors (not included) into each hole and tap gently with a hammer until
the anchor is fl ush with the wall.
3. Insert a screw (not included) into each wall anchor and tighten until the screws only
stick out about a 1/2 inch.
4. Plug the power cord into the power input of the camera.
5. Locate the wall mounting holes on the bottom of the camera base.
6. Slide the holes over the screws sticking out of the wall.
7. Confi rm that the camera is secure, if it is loose you may
have to tighten the screws more.
8. Use wall clips (not included) to secure the power cord
away from the crib or the baby's reach.
9. Connect the other end of the adapter into an available
wall outlet.

Night Vision

The camera is equipped with Invisible IR (infrared) LEDs
which keep the nursery dark. The LEDs are located on
the front of the camera and allow you to see up to 15
feet in complete darkness so you can check on your baby
at any time of night. The night vision LEDs will activate
automatically when the Light Sensor on the front of the
camera detects that the light levels are too low.
LIGHT
SENSOR
INVISIBLE
LEDs
12
OPERATION
Using the Zoom / Pan & Tilt functions
While in Zoom, the screen allows you to Pan/Tilt the image up, down, left and right on
the screen (not the camera angle). Press Select + to exit the Zoom / Pan & Tilt function.

Adjusting the volume

Mute High
Note: Placing the monitor and camera too
close together will create feedback. DECREASE
or MUTE the volume and move the camera
away from the monitor.
13