Battery Installation - Camera (Optional); Connecting The Power Adapters; Charging The Monitor; Get The Most Out Of Your Rechargeable Battery - Lenovo ayden User Manual

SETUP

Battery Installation - Camera (optional)

The camera unit can be powered using 4 AAA batteries instead
of the included adapter.
1. Gently remove the Battery Compartment Cover on the
bottom of the camera base, using a small phillips (cross)
head screwdriver.
2. Insert 4 AAA batteries in the compartment (not included),
paying close attention to the labelled polarity markings.
3. Replace the battery compartment cover using the
small screwdriver.
4. The Power LED will fl ash when the battery charge is low.

Connecting the Power Adapters

1. Connect the Power Adapter marked
Monitor to the Power Input on the
side of the Monitor.
2. Press and hold the Power button
on the side of the monitor to turn
the monitor ON.

Charging the Monitor

There are two ways to determine the battery
power status:
1. The LED Ring on the front of the monitor
2. The icon in the top right corner of the main screen
EMPTY FULL
Battery
Compartment
cover
SOLID BLUE = BATTERY FULLY CHARGED
QUICK FLASHING BLUE = BATTERY LOW
FLASHING PINK = PAIRING UNSUCCESSFUL
8
SETUP
1. Connect the Power Adapter marked
Camera to the Power Input on the back
of the Camera.
2. Slide the ON/OFF switch on the side of
the camera to the ON position. Power
LED will be a solid red.

Get the Most Out of Your Rechargeable Battery

Fully charge your battery before
fi rst use
Charge battery before battery is
fully drained.
Avoid extreme heat or cold as this
will aff ect the battery life.

Screen Icons

Lullabies
Peep Mode
Camera
Brightness
Sound Sensitivity
Pairing
Temperature
Turn LCD screen OFF. Press
POWER button on side of
monitor ONCE.
PEEP Mode: After 1 minute of
inactivity, monitor enters standby/
sleep mode (when activated)
Adjustable Brightness: Decrease
screen brightness
9