Related Manuals for Pacific Rhino PFS 8
Summary of Contents for Pacific Rhino PFS 8
- Page 1 PACIFIC Rhino PFS 8 8” Drum Sander (Expandable Drum) From Serial Number 05400 (110 Volt) OWNERS MANUAL & OPERATING INSTRUCTIONS MAY 2010 REF. 179 PART # R000513...
- Page 2 NORTH AMERICAN SAFETY INSTRUCTIONS WARNING: This floor sanding machine must be grounded. This floor-sanding machine shall be grounded while in use to protect the operator from electric shock. The machine is provided with a three-conductor cord and a moulded three-contact grounding type attachment plug to fit the proper grounding type receptacle.
-
Page 3: Table Of Contents
SPARE PARTS Use Pacific Floor Care genuine spare parts only for service and repair. Use of non-approved parts will void the product warranty. See the back cover of this manual for the terms and conditions of the Pacific Floor Care Limited Warranty. -
Page 4: Specification
200mm 8(") wide dynamical balanced Pack. Place the wedge on the floor and roll the high performance drum with expandable Rhino PFS 8 onto the wedge in the centre of the drum rubber. machine until it comes to a stop to prevent the Abrasive: 200mm (8") x 493mm (19.5") resin... -
Page 5: Set Up
The floor sander is now ready for use. Tighten the clamp bracket firmly. Always ensure Note: Use Pacific Floor Care genuine floor sander that the clamp bracket is tight, check periodically abrasives for the best sanding performance and during use. -
Page 6: Operation
Dampen the dust bag down CAUTION - the Pacific Rhino PFS 8 Drum with water to reduce the risk of fire. Never reuse Floor Sander is a powerful machine. -
Page 7: Floor Sanding Technique
FLOOR SANDING TECHNIQUE the wood grain. Start with a medium grit abrasive. Complete the first cut with the Pacific Rhino PFS 8 Drum Sander then sand up to the baseboards and Pacific Rhino PFS 8 Drum Sander - a powerful floor... - Page 8 FLOOR SANDING TECHNIQUE Level uneven floors. sanded boards unsanded boards level very uneven floors by sanding diagonally in both directions Plank and Strip Floors - sand in the Sand main floor area. direction the boards are laid, with the wood grain. unsanded boards Parquet and Wood Block Floor sand in the direction of the main...
-
Page 9: Floor Sander Abrasive Guide
FLOOR SANDER ABRASIVE GUIDE Abrasive Grade Floor Type and Condition For removing surface coatings from old floors such as varnish, stains and Grit P24 Open Coat wax polishes. For the rapid sanding and removal of scratches and marks. (Very Coarse non-glogging) Sanding level the joints of sub-flooring like particle board and masonite. -
Page 10: Service And Routine Maintenance
The Pacific Rhino PFS 8 Drum Sander is subject to replace if necessary with new belts. To replace high speeds. All screws should be fitted using a reverse the above procedure taking care to avoid suitable thread lock compound. -
Page 11: Care Of Motor
Owners Pack. Place the wedge on the floor and Check the condition of the rear wheels (Rollers roll the Rhino PFS 8 onto the wedge in the centre of the Ref.61). The wheels must be free from dirt and machine until it comes to a stop to prevent the drum rotate freely. - Page 12 Screw Ref.34 into position. Both the bearing fit and the main frame fit Rhino PFS 8 Low Voltage Switch. Cover 'A' Dust Membrane Cover 'B'...
-
Page 13: Electrical Testing
The button must only lock 'ON' when current is present. Note: The Pacific Rhino PFS 8 Drum Sander features a fully protected circuit breaker which incorporates 11. Finally test the machine once again to ensure 'Low Volt Protection'. -
Page 14: Trouble Shooting
TROUBLE SHOOTING FAULT CAUSE ACTION The machine does not run. The power cable is not Connect the power cable to the connected to the power supply. power supply. The overload protection has Allow to cool, switch on. been activated. The motor brushes are worn. Replace the motor brushes. -
Page 15: Rhino Pfs 8 Parts Drawing
RHINO PFS 8 PARTS DIAGRAM 127 85 49 46 145 146... - Page 16 RHINO PFS 8 PARTS DIAGRAM 96 95 62 89 87 62 93 96 97 102 HT8 EX MULTI-SPEED DRUM FLOOR SANDER From Serial Number (220/240 Volt) & (110/120 Volt) OWNERS MANUAL & OPERATING INSTRUCTIONS APRIL 2006 © Hiretech REF. 179...
-
Page 17: Rhino Pfs 8 Parts List
RHINO PFS 8 PARTS LIST Ref. PSTK Pack Description Ref. PSTK Pack Description Qty. Qty. 001 R962308 Screw 058 R07037 25 Disposable Paper Dust Bag HT8 Pack 2 002 R980652 Washer (box 25) 003 R162019 Clamp Handle 058 R07039 50 Disposable Paper Dust Bag HT8 (box 50) - Page 18 RHINO PFS 8 PARTS LIST Ref. PSTK Pack Description Ref. PSTK Pack Description Qty. Qty. 121 R163008 Fan Motor 179 R000513 Owners Manual & Operating Instructions 123 R167802 Shield Pulley 200 R101219 Floor Roller Assembly 124 R024885 Bearing Drum Shaft EX...
-
Page 19: Rhino Pfs 8 Circuit Diagram
RHINO PFS 8 CIRCUIT DIAGRAM imited UNDER VOLTAGE AND OVERLOAD PROTECTED NOTE: TERMINALS 3 & 4 NOT USED SWITCH U/V COIL LEADS CABLE REF. 20 ARMATURE GREEN/YELLOW (GREEN - N. AMERICA) FIELD BROWN (BLACK - N. AMERICA) BLUE (WHITE - N. AMERICA) CABLE REF. -
Page 20: Service & Repair
Should any part fail in the period of two years from the date of the original purchase as a result of a defect, Pacific Floor Care will (at it’s option) either repair or replace the part without charge provided that the machine has been operated in accordance with the Owners Manual and Operating Instructions.
Need help?
Do you have a question about the Rhino PFS 8 and is the answer not in the manual?
Questions and answers