At The End Of A Wash Program; Adding An Item To The Wash Cycle; Delay Start; Rinse Aid And Salt Indicator Neons - Venini VDW61S User Manual

At the end of a wash program

o When the wash program is finished a buzzer will sound.
o Open the door of the appliance.
o Use the ON/OFF button to switch the dishwasher off.
o Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still not and more
susceptible to breakages. They will also dry better.
Adding an item to a wash cycle
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent tablet may have
already released or you could have hot water escaping.
o Slightly open the door of the appliance and wait for a minute before
fully opening the door to avoid scalding by the hot water.
o The cycle will pause. The machine will emit a beep and display error
code "E-1" in the display.
o Add the item and then close the door. The cycle will resume after
approximately 10 seconds.

Delay start

o Set your desired wash program as outlined on page 18.
o Press the delay start button to delay the start of the wash.
o Keep pressing the delay start button until your desired amount of
delay is displayed (in hours).
o The maximum amount of delay is 24 hours.
Rinse aid indicator
o The rinse aid indicator on the control panel will let you know when
the appliance needs rinse aid adding to it.
o The light indicates that you need to add rinse aid to the
appliance. You should follow the procedure outlined on pages 11.
20