Product Description; Product Application; Eatures - Goodman GDVC80703B Installation Instructions Manual

L L L L L R R R R R
O C O CA A A A A T I O N O C O C O C T I O N T I O N T I O N T I O N E Q U I R E M E N T E Q U I R E M E N TS S S S S A N D E Q U I R E M E N T E Q U I R E M E N T E Q U I R E M E N T
Product limited warranty certificates can be viewed at
www.goodmanmfg.com or www.amana-hac.com. Each product
overview page contains a Product Warranty link; by clicking on it
you will be able to view the limited warranty coverage for that
specific product. To view warranty registration information, click on
the Product Warranty text on the left navigation panel on the home
page of each website. The Online Product Registration pages are
located in this same section.
T
O PREVENT PROPERTY DAMAGE
,
FIRE DO NOT INSTALL THIS FURNACE
.
RECREATIONAL VEHICLE
P P P P P D D D D D
RODUCT RODUCT RODUCT RODUCT RODUCT ESCRIPTION ESCRIPTION ESCRIPTION ESCRIPTION ESCRIPTION
F F F F F

EATURES

EATURES EATURES EATURES EATURES
This furnace is a part of the ComfortNet™ family of products. The
CTK01 ComfortNet thermostat kit allows this furnace to be installed
as part of a digitally communicating system. The ComfortNet sys-
tem provides automatic airflow configuration, enhanced setup fea-
tures, and enhanced diagnostics. It also reduces the number of
thermostat wires to a maximum of four. It may be also installed as
part of a "legacy" system using a standard 24 VAC thermostat.
This product may also be installed with the ComfortNet thermostat
and a non-ComfortNet compatible single stage air conditioning
unit. However, this reduces the benefits of the ComfortNet system
as the enhancements will only apply to the furnace.
P P P P P A A A A A
R R R R R O D U C T O D U C T O D U C T O D U C T PPLICA A A A A TION PPLIC PPLIC TION TION TION
O D U C T PPLIC PPLIC TION
This furnace is primarily designed for residential home-heating ap-
plications. It is NOT designed or certified for use in mobile homes,
trailers or recreational vehicles. Neither is it designed or certified
for outdoor applications. The furnace must
(i.e., attic space, crawl space, or garage area provided the garage
area is enclosed with an operating door).
This furnace can be used in the following non-industrial commer-
cial applications:
Schools, Office buildings, Churches, Retail stores, Schools, Office buildings, Churches, Retail stores, Schools, Office buildings, Churches, Retail stores, Schools, Office buildings, Churches, Retail stores, Schools, Office buildings, Churches, Retail stores,
Nursing homes, Hotels/motels, Common or office areas Nursing homes, Hotels/motels, Common or office areas Nursing homes, Hotels/motels, Common or office areas Nursing homes, Hotels/motels, Common or office areas Nursing homes, Hotels/motels, Common or office areas
In such applications , the furnace must be installed with the follow-
ing stipulations:
• It must be installed per the installation instructions provided
and per local and national codes.
• It must be installed indoors in a building constructed on
site.
• It must be part of a ducted system and not used in a free
air delivery application.
• It must not be used as a "make-up" air unit.
• All other warranty exclusions and restrictions apply.
C C C C C
A N D A N D A N D A N D O N S I D E R O N S I D E R O N S I D E RA A A A A T I O N S O N S I D E R O N S I D E R
WARNING
,
PERSONAL INJURY OR DEATH
,
IN A MOBILE HOME TRAILER
must must must be installed indoors must
T I O N S T I O N S T I O N S T I O N S
This furnace may be used as a construction site heater ONL
following conditions are met:
• The vent system is permanently installed per these
installation instructions.
• A room thermostat is used to control the furnace. Fixed
jumpers that provide continuous heating CANNOT be
used.
• Return air ducts are provided and sealed to the furnace.
• A return air temperature range between 60ºF (16ºC) and
80ºF (27ºC) is maintained.
• Air filters are installed in the system and maintained during
DUE TO
construction, replaced as appropriate during construction,
,
OR
and upon completion of construction are replaced.
• The input rate and temperature rise are set per the furnace
rating plate.
• 100% outside air is provided for combustion air
requirements during construction. Temporary ducting can
be used.
NOTE: NOTE: NOTE: Do not connect the temporary duct directly to the NOTE: NOTE:
furnace. The duct must be sized according to the
instructions under Combustion and Ventilation Air
Requirements, Section 5.3.3.
• The furnace heat exchanger, components, duct system,
air filters and evaporator coils are thoroughly cleaned
following final construction clean up.
• All furnace operating conditions (including ignition, input
rate, temperature rise and venting) are verified according
to these installation instructions.
NO NO NOTE: NO NO TE: TE: TE: TE: The Commonwealth of Massachusetts requires that the
following additional requirements must also be met:
• Gas furnaces must be installed by a licensed plumber or
gas fitter.
• A T-handle gas cock must be used.
• If the unit is to be installed in an attic, the passageway to
and the service area around the unit must have flooring.
T
O PREVENT PROPERTY
,
FIRE DO NOT INSTALL
RECREATIONAL
T T T T T o ensur o ensur o ensur o ensur o ensure pr e pr e proper fur e pr e pr oper fur oper fur oper fur oper furnac
tain the furnace in accordance with these installation and op- tain the furnace in accordance with these installation and op-
tain the furnace in accordance with these installation and op- tain the furnace in accordance with these installation and op- tain the furnace in accordance with these installation and op-
eration instructions, all local building codes and ordinances. eration instructions, all local building codes and ordinances.
eration instructions, all local building codes and ordinances. eration instructions, all local building codes and ordinances. In eration instructions, all local building codes and ordinances.
their absence, follow the latest edition of the National Fuel Gas
Code (NFPA 54/ANSI Z223.1), and/or CAN/CSA B149 Installation
Codes, local plumbing or waste water codes, and other applicable
codes.
A copy of the National Fuel Gas Code (NFPA 54/ANSI Z223.1) can
be obtained from any of the following:
American National Standards Institute American National Standards Institute American National Standards Institute American National Standards Institute American National Standards Institute
6
WARNING
,
DAMAGE PERSONAL INJURY
THIS FURNACE IN A MOBILE
.
VEHICLE
nac nac nac nace oper e opera a a a a tion, install e oper e oper e oper tion, install, oper tion, install tion, install tion, install
1430 Broadway
ONL ONL ONLY Y Y Y Y if the
ONL
OR DEATH DUE TO
, ,
HOME TRAILER OR
, oper , oper , oper , opera a a a a t t t t t e and main- e and main- e and main- e and main- e and main-