Download Print this page

Monster SC6X1 Instruction Manual page 12

Advertisement

Turning Steam Cleaner On
4
• Plug electrical cord into a power outlet.
• Press the Power Switch.
• The Steam Cleaner will heat up in approximately 6-7 minutes.
• When the green Steam Ready Light illuminates, the Steam Cleaner is
ready to use.
• Some water may come out from the nozzle on the attachment. This
is unheated, condensed water in the Hose and is normal.
NOTE: Do not turn on Steam Cleaner if Water Tank is empty.
Steam Release
5
To release steam from the Steam Cleaner,
slide forward the trigger found on the Steam
Gun. Steam will continue to be released while
the trigger is in the forward position. To stop
the steam, slide the trigger backward.
IMPORTANT: When the Steam Cleaner has run out of water,
steam output will cease. Follow refill instructions to use
your Steam Cleaner again.
Refilling the Boiler During Use
6 6
WARNINGS
• ALWAYS vent the Boiler (release all pressure/steam) before opening
Boiler Cap. Venting is done by sliding the Steam Control Trigger forward
to the "On" position. If no steam is emitting then there is no pressure
in the Boiler and the Boiler Cap is safe to open. Slide back the Steam
Control Trigger to the "Off" position.
• Always unplug the unit and be sure it has cooled off before re-filling
the Boiler – at least 5 minutes.
• NEVER turn on Steam Cleaner if the Boiler is empty!
When water in the boiler runs out, steam will stop emitting from the Steam
Cleaner. To refill the Boiler with water, follow the steps below:
• Switch off the Steam Cleaner by depressing the Power Switch and
unplug the appliance from the power outlet.
• Carefully and slowly turn the Boiler Cap counter-clockwise. If a hissing
sound is heard, residual steam and pressure remain in the Boiler. Wait
until the last of the steam and pressure escapes and the hissing stops
before removing the Boiler Cap.
• Take care of where the Boiler Cap is placed as the underside of the
cap is very hot. Ensure there are no children present who may pick up
the hot cap and cause burns to themselves.
• Allow the Steam Cleaner to cool for at least 5 minutes before refilling
with water.
• Refill the Boiler with a maximum of 1.2 litres (2 pints) of water using
12
Using Your Steam Cleaner

Advertisement

loading