Download Print this page

Monster SC6X1 Instruction Manual page 11

Advertisement

Filling Steam Cleaner with Water
3
WARNINGS
• Carefully read all instructions before removing Boiler Cap.
• Always switch off the appliance and be sure it has cooled before filling
the Boiler.
*IMPORTANT*
Use ordinary tap water. Use distilled or demineralized water if tap water is too
hard. DO NOT add detergents, perfumes, oils or other chemical substances
to the Boiler. This will cause damage to the Steam Cleaner and void the
warranty.
Follow these instructions to avoid overfilling the Boiler.
• Be sure the appliance is switched off at the Power Switch and unplug the
appliance from the power outlet.
• Carefully remove the Boiler Cap by
turning it counter-clockwise.
• Pour in a maximum of 1.2 litres / 2
pints of water using the Filler Funnel
provided. Do not overfill the Boiler,
excess water in the Boiler will be
flushed out of the unit, resulting in wet
floors or wet surfaces when cleaning.
Dry steam will only emit if the Boiler is not overfilled.
• Replace the Boiler Cap by turning it clockwise.
Do not over-tighten the Boiler Cap, finger tight is
sufficient.
• Plug electrical cord into a 3-prong grounded
power outlet.
• Turn on the Power Switch.
• The Steam Cleaner will heat up, produce steam and the Boiler will
become pressurised.
• When the green Steam Ready Light turns on the Steam Cleaner is ready
to use. Note: the green Steam Ready Light may turn on and off during
use, this is normal and not a fault.
• If using cold water, heating time is about 6-7 minutes. Using hot water will
reduce the heating time.
NOTE: Do not turn on Steam Cleaner if Boiler is empty.
CAUTIONS
• Always drain condensed water from Hose before use or if appliance has
been left idle for a period of time. To drain, direct Nozzle into a sink and
slide Steam Control trigger on Steam Gun forward. Once Hose is empty,
resume normal use. Never direct Nozzle toward people, animals or plants.
• Extreme care should be taken when opening the Boiler Cap as it may
become hot during use and escaping steam can cause scalding.
Max. 1.2l
11
Before Use

Advertisement

loading