Setting The Input Functions - Tascam DR-05 Owner's Manual

4–Recording

Setting the input functions

1 Press the MENU button to open the
Screen.
2 Use the + or − button to select
, and press the Á button.
SETTING
screen appears.
REC SETTING
The following input settings are made in this screen.
Use the  or ¯ button or the + or − button to
select the following settings.
MIC POWER:
When connecting a microphone that requires
plug-in power, set this to
is .
OFF
46
TASCAM DR-05
M ENU
REC
. The factory default
ON
LOW CUT:
The factory default setting of the low cut filter
is , but you can also select
OFF
as the cut-off frequency for a low cut
120Hz
filter.
CAUTION
• Set MIC POWER to OFF when using the built-in mic or
connecting a dynamic microphone or microphone with
a built-in battery. If set to ON, the plug-in power may
damage such microphones.
• Use headphones to monitor when you are recording with
a microphone. If you use speakers to monitor, the sound
output from the speakers may also be recorded, causing
a poor recording and even feedback.
NOTE
MIC POWER and LOW CUT can be set when recording/in
recording standby.
TIP
The LOW CUT filter can reduce noise such as offensive wind
noise from air-conditioners and projectors.
, or
40Hz 80Hz