GLOBAL ASSISTIVE DEVICES VibraLITE 2 Instruction Manual page 3

FIRST TIME SETTING OF YOUR CALENDAR/CLOCK
(You must have this set for your Alarm Settings to be accurate.)
When setting the Calendar & Clock, the rotation for setting is
Seconds, Hour, Minutes, 12/24Hr, Date, Month, Day of Week.
ONLY when the digits are BLINKING can you set or change the
setting. The clock will stop blinking when no button is pressed for
two minutes. You cannot switch to another mode of operation while
the display is blinking. To exit and stop the blinking, push
LAP/RESET button.
1. Repeat pressing the MODE button until the (1) CALENDAR
CLOCK operating mode shows on the display.
2. Press & Hold the LAP/RESET button until the seconds digits
begin to BLINK.
Press START/STOP button to reset the seconds display to 00.
3. Press the MODE button. The hour digits will begin to BLINK.
Press the START/STOP button to rotate to the correct hour of
the day.