UTG L.I.B.R.E. LT-EL700 Owner's Manual

Advertisement

L.I.B.R.E
STROBE
L.I.B.R.E
MEMORY
20
Lumen
700
Lumen
LT-EL700
LED Flashlight
MUF028011504

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L.I.B.R.E. LT-EL700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for UTG L.I.B.R.E. LT-EL700

  • Page 1 L.I.B.R.E STROBE L.I.B.R.E MEMORY Lumen Lumen LT-EL700 LED Flashlight MUF028011504...
  • Page 2 CAUTION! If you need to mount the flashlight onto a firearm, make sure firearm is not loaded before Turn off the light when not in use to conserve battery power. installation. Remove magazine and examine chamber. Use safe handling procedures at all times.
  • Page 3 Component Illustration LT-EL700 (Model Number) LT-EL700 AQN0040UB98U (Example Serial Number) Aircraft Aluminum Main Body Length 170.2mm (6.7”) Battery Compartment Main Body Diameter 25.4mm (1.00”) Rubber Spacer Ring Weight with Battery 243.8g (8.6 oz) Law Enforcement Rated Rolling Stop Shoulder Bulb Type 37mm IRB with CREE U2 LED Voltage Water Resistant...
  • Page 4 Installation & Operation Battery and Spacer Ring Installation Pressure Switch Operation Push Button Operation Rubber Spacer Ring Tactical Grip Assist 1. Unscrew the flashlight end cap by 2. While the end cap is removed, the Press and release the button in the center of 1.
  • Page 5 Dimming Technology Operation L.I.B.R.E Memory Strobe HOLD 1 CLICK 2 CLICKS Lumens Lumens Main Power Button Lumen Control Pad While the flashlight is “on”, Once you have achieved A double tap on the Lumen press and hold the Lumen your preferred brightness Control Pad while the Control Pad to dim the light setting, the flashlight will...
  • Page 6 Mounting the Flashlight 1. The LT-EL700 package includes a Tactical 2. To install the flashlight, loosen the 5. Tighten the screws evenly with 6. Attach the assembled flashlight and Angled Offset Ring Mount with Spacer. screws with included Allen Wrench and included Allen Wrench (max.
  • Page 7 Maintenance Replacement Parts 1. Maintain the metal surface of the flashlight by removing any dirt or sand with a soft brush to avoid scratching the finish. 2. Store the flashlight in a cool dry place when not in use. Be careful to avoid contact with acid, alkaline or corrosive chemicals.
  • Page 8 Disclaimer and Limitation of Liability One Year Limited Warranty Leapers is pleased to offer suggestions of the use of its products, however Leapers neither This warranty covers defects in materials and workmanship of the product, provided assumes responsibility for any omissions or errors nor assumes liability for any damages that that they are purchased from an authorized distributor and purchased and used in the result from the use of its products in accordance with information provided by Leapers, whether United States.

Table of Contents