Sony BDV-N9100W Operating Instructions Manual page 75

The[Control for HDIVII] f unction does
notwork("BRAVIA" S ync).
--_ Check that [Control for HDM[] is set
to [On] (page 64).
---+ [f you change the HDM[ connection,
turn the system off and on again.
---+ [f power failure occurs, set [Control
for HDM[] to [Off], then set [Control
for HDM[] to [On] (page 64).
---+ Check the following and refer to the
operating instructions supplied with
the equipment.
• The connected equipment is
compatible with the [Control for
HDM[] function.
• The connected equipment' s setting
for the [Control for HDM[] function
is correct.
Thesystem cannot c onnect tothe
network.
---+ Check the network connection
(page 27) and the network settings
(page 65).
Youcannot c onnect y ourPCtothe
Internet after[Wi-FiProtected Setup
(WPS)]is performed.
---+ The wireless settings of the router may
change automatically if you use the
Wi-Fi Protected Setup function before
adjusting the settings of the router. [n
this case, change the wireless settings
of your PC accordingly.
Thesystem cannot c onnect tothe
network or thenetwork connection i s
unstable.
--+ Check if the wireless LAN router is on.
---+ Check the network connection
(page 27) and the network settings
(page 65).
---+ Depending on the usage environment,
including the wall material, radio wave
reception conditions, or obstacles
between the system and the wireless
LAN router, the possible
communication distance may be
shortened. Move the system and the
wireless LAN router closer to each
other.
---+ Devices that use a 2.4 GHz frequency
band, such as a microwave, Bluetooth,
or digital cordless device, may
interrupt communication. Move the
main unit away from such devices, or
turn off such devices.
---+ The wireless LAN connection may be
unstable depending on the usage
environment, especially while using
the Blu(,tooth function of the system.
[n this case, adjust the usage
environment.
Thewirelessrouter y ouwantis not
shown inthewirelessnetwork list.
---+ Press RETURN to return to the
previous screen, and try [Wireless
Setup(built-in)] again. If the wireless
router you want is still not detected,
select [Add a new' address.] from the
network list, then select [Manual
Registration] to input a network name
(SSID) manually.
o.
O
-i
a"
3
m
o
-i
75us