Description Of The Inputs And Outputs - ABB L240 Series Installation, Commissioning & Operation

12.3 Description of the inputs and outputs

Terminal Description
01 +12 V
02 - (0V)
03 + (+12 V)
04 - (0 V)
05 A (data line)
06 B (data line)
07 Sabo (Cct)
08
09 +ANT
10 M
11 +
12 D
13 P
14 M
15 Lock (+12 V)
16 (0 V)
17 (Control)
18 (feedback)
19 Magnet (Intrusion
cct)
20
21 (End of line resistor
(2.7 kOhm)
22
23 Lock (Lock cct)
24
25 Transistor output T1
26 C
27 Transistor output T2
28 Transistor output T3
29 C
30 Transistor output T4
L240/BS
Function
Connection for the separate power supply of the
bolt lock from the XIB security bus, e.g. on an
Intrusion Alarm Panel L240 to "V+/V-". The power
supply and the XIB security bus must be supplied
from the same Intrusion Alarm Panel (common
reference voltage).
Connection for external XIB security bus
Connection for the cover tamper contact of a
SafeKey Wall reader with keypad
Not used
Wired connection for a SafeKey Wall Reader
Connection for a bolt lock (required with SafeKey
Wall Reader)
Magnetic reed contact connection for monitoring
of door opening
Lock bolt switching contact connection for
monitoring of the door lock
Internal alarm: Switches +12 V via a 470 Ohm
series resistor on an internal alarm (Imax=20 mA)
0 V (common for terminal 25 and 27)
Access: Switches +12 V for six seconds via a 470
Ohm series resistor should a valid key
code/chipkey be used (Imax=20 mA)
External/internal set: Switches +12 V via an 820
Ohm series resistor if the Intrusion Alarm Panel is
internally or externally set (Imax=15 mA)
0 V (common for terminal 28 and 30)
Ready to set: Switches +12 V via an 820 Ohm
series resistor if the Intrusion Alarm Panel is
externally set (Imax=15 mA)
Connection wire
Grey wire
Pink wire
Yellow wire
Green wire
Brown wire
White wire
Red wire
Blue wire
Yellow and black
wire
Grey wire
Two adjacent
wires
Two other
adjacent wires
Blue wire
Black wire
84