Table of Contents
Advertisement
L240/MG2
After teach-in the Detector Circuit Module L240/MG2 has two circuits each
with the following properties:
(also refer to
Properties of the circuit types
•
Standard or EIB/KNX
•
Intrusion circuit (Cct)
•
Cct off int off
•
Cct off ext. off
•
Silent alarm off
•
Print unset off
The circuits are thus active with internal and external setting.
5
button
"? Cct Fault" on the keypad the faults of the individual circuit are
displayed (e.g. Cct14 or the stored text for the detector).
The circuit groups can also be reprogrammed to other circuit types (e.g.
personal attack or technology circuits).
Area assignment
On the programming level (Engineer menu) select function "07=Concs".
•
Concentrator
Number _
•
Enter the address of the circuit.
Concentrator-0x
Area-1
•
Enter the circuit area and exit the Hardware menu with button
Monitoring tamper contact yes/no
•
Select the function "13=2-Conc Tamper" in the programming level.
13=2-Conc Tamper
15=Defaults
After the supply voltage is applied, monitoring of all tamper contacts is
reactivated.
•
Successively for all logged on Detector Circuit Modules L240/MG2, the
monitoring of the panel tamper can be activated (ON) or deactivated
(OFF).
•
2-Conc Tamper
2-Conc. xx-On
The panel tamper is activated on Detector Circuit Module L240/MG2 with
the XIB address 03.
After commissioning:
•
Apply the spring and the pin for the panel tamper contact.
•
Activate monitoring of the panel tamper contact.
•
Screw on the module onto the supporting ring with the enclosed fixing
screws on the FM switch socket.
•
The cover of the socket should be screwed on with the enclosed cover
screw.
•
Perform a function test of the tamper cover contact by opening the socket
cover (tamper alarm on the Intrusion Alarm Panel).
The screw for opening the socket cover should be sealed with the enclosed
VdS label.
chapter 8.1.3.2 on page
After pressing
X.
56).
74
Advertisement
Table of Contents
