Supplying Power; Installing Tools For Ur44 - Steinberg UR44 Getting Started

Supplying Power

Supplying Power
1.
Make sure that the [P]
(Standby/On) switch is in the
standby position (N).
2.
Insert the plug of the AC
power adaptor into the DC IN
[12V] jack on the device.
3.
Insert the plug of the AC
power adaptor into a proper
AC outlet.
WARNING
Only use the included AC power adaptor
(or an equivalent recommended by
Yamaha). Using the wrong adaptor can
result in damage to the device or
overheating.
CAUTION
Remove the electric plug from the outlet
when the device is not be used for
extended periods of time, or during
electrical storms.
NOTICE
To avoid generating unwanted noise,
make sure there is adequate distance
between the power adaptor and the
device.
4
UR44 Getting Started
Installing TOOLS for
UR44
TOOLS for UR44 is necessary when
connecting the device to a computer.
Make sure to install it before initially
using the device. Follow the steps
below to install the TOOLS for UR44.
NOTE
• You are only permitted to use this
software pursuant to the terms and
conditions of the "License Agreement"
shown during the installation.
• Future upgrades of application and
system software and any changes in
specifications and functions will be
announced at the following website.
http://www.steinberg.net/
• The eLicenser Control Center (eLCC) for
controlling the product license is installed
at the same time.
Windows
1.
Make sure that the [P]
(Standby/On) switch is in the
standby position (N).
2.
Disconnect all USB devices
other than the mouse and
keyboard from the computer.
3.
Start the computer and log
on to the Administrator
account.
Exit any open applications and
close all open windows.