Starting And Stopping Engine - Makita EA3600F Original Instruction Manual

STARTING AND STOPPING ENGINE

Do not start the engine before the chain saw is completely assembled and
Move at least 3 meters (10 ft.) away from the place where the chain saw is
fuelled.
Never pull the rope to the full extension.
Return the starter grip gently into the housing. Otherwise released starter grip
may hit your body or it may not rewind appropriately.
ground.
3. Hold down the rear handguard with your right foot.
4. Start the engine in accordance with engine circumstances as follows.
Cold start
1. Push the primer pump several times until fuel comes into the primer pump. (In
3. Pull the starter grip slowly until feeling compression. Then pull it strongly. It may
position. Then pull the starter grip strongly again until the engine starts running.
1. Push the primer pump several times until fuel comes into the primer pump. (In
position.
3. Pull the starter grip slowly until feeling compression. Then pull it strongly. It may
the steps of cold start (see the section "Cold start").
release it.
19