Makita DTW1001 Instruction Manual page 7

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
Fig.4: 1. Switch trigger
CAUTION:
Before inserting the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
NOTE:
ing the switch trigger for about 6 minutes.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Fig.5: 1. Lamp
Fig.6: 1. Button
ton for one second again.
Changing the impact force
Fig.8: 1. Changed in three steps 2. Hard 3. Medium
4. Soft 5. Button
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Impact force grade displayed on
panel
Hard
Medium
Remaining
capacity
Blinking
may have
malfunctioned.
for
is pressed, the number of blows changes in three steps.
Maximum blows
DTW1001 DTW1002
2,200 min
2,000 min
approximately 10 seconds after releasing the switch
trigger.
even if pulling the trigger.
NOTE:
on, the lamp status is OFF.
NOTE:
this case, cool down the tool before operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE:
status cannot be changed.
NOTE: For approximately 10 seconds after releasing
the switch trigger, the lamp status can be changed.
Reversing switch action
Fig.7: 1. Reversing switch lever
- CAUTION:
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
-
terclockwise rotation.
tion, the switch trigger cannot be pulled.
DTW800
-1
-1
7 ENGLISH
Always check the direction of
Use the reversing switch only after
When not operating the tool,
Application
-
-