Remington Power Pro 500V Operating Instructions Manual page 22

Tool Disassembly and
Assembly
B. INSERTING BAFFLE ASSEMBLY
1. Insert baffle assembly with o-ring into handle and tighten (see Figure 15).
Housing Handle
Baffle Assembly
C. REPLACING ADVANCE BAR
1. Place advance bar and spring into housing (see Figure 16).
2. Secure advance bar by inserting the advance pin through the housing, advance
bar, and spring.
3. Place cover onto housing and align holes. Insert screws into cover and tighten
with 3mm hex wrench (see Figure 16).
Screws
Cover
Advance Pin
D. REPLACING TRIGGER AND PAWL ASSEMBLY
1. Assemble pawl components and screw into housing using a phillips head
screwdriver (see Figure 17).
2. Slide trigger into housing (see Figure 17).
Figure 17 - Replacing Trigger and Pawl Assembly
Figure 15 - Inserting Baffle Assembly
Figure 16 - Replacing Advance Bar
Housing
O-Ring
Advance Bar and Spring
NOTE: Spring and plate
are NOT reversible.
Bent arm on spring must
be toward plate.
Pawl
Assembly
Trigger
22
Housing
114918