Remington Power Pro 500V Operating Instructions Manual page 20

Tool Disassembly and
Assembly
E. REMOVING FIRING PIN
1. Slide firing pin guide back so the slot in the firing pin guide lines up with the slot
in the outer liner assembly.
2. Pull the sear out of the aligned holes (see Figure 8).
3. Slide firing pin guide off of the outer liner assembly (see Figure 9). Pull the firing
pin assembly with sear spring out of the outer liner assembly. Remove sear
spring from firing pin assembly (see Figure 9).
4. Remove transfer pin and push pin from outer liner assembly (see Figure 9).
Firing Pin
Guide
Outer Liner Assembly
Figure 8 - Removing Sear
F. REMOVING TRIGGER AND PAWL ASSEMBLY
1. Slide trigger out of housing (see Figure 10).
2. Using a phillips head screw driver, loosen screw and remove pawl assembly
components from housing (see Figure 10).
Figure 10 - Removing Trigger and Pawl Assembly
Sear
Figure 9 - Removing Firing Pin Guide,
Firing Pin Assembly, Sear Spring,
20
Outer Liner
Assembly
Transfer Pin
Push Pin
Transfer Pin, and Push Pin
Housing
Pawl Assembly
Trigger
Sear Spring
Firing Pin
Guide
Firing Pin
Assembly
114918