Table of Contents
Advertisement
3. Once you have selected the mode and temperature,
the display returns to the current room temperature
and gradually increases as the room warms.
4. If you selected an Auto mode and the heater does
not start, make sure the set temperature is higher
than the current room temperature.
5. To turn the unit off keep pressing the "mode" Button
until all mode indicator lights are not illuminated.
NOTE: The Mode Indicator Light will flash in the AUTO
mode if the set temperature is lower than the current
room temperature displayed on the Display, this is also
the same if the unit has reached the required set
temperature.
NOTE: In Auto mode, it is normal for the heater to cycle
ON and OFF as it maintains the programmed
temperature. To prevent the unit from cycling, raise the
thermostat setting.
The Digital Thermostat remembers the previous
temperature setting after the unit is turned off. However,
if the unit is unplugged, the digital thermostat resets and
no longer remembers the previous temperature setting.
PROGRAMMABLE TIMER
You can program your heater to turn on at a preset time
or turn off after a set amount of time.
Setting the On Timer:
1. With the heater off, press and hold (+) and (-)
simultaneously until the display flashes and display
the number "0".
2. Press (+) or (-) to select the amount of time you
would like to pass before the heater turns on.
3. After setting the timer, the display shows a red dot
next to the current room temperature on the display
to indicate that the timer is activated.
4. After the programmed length of time has passed, the
heater automatically turns on Auto HI at 24°C for 2
hours.
FEAT UR E S - O P E RAT I O N S
Setting the Off Timer:
1. Select the desired mode and/or temperature.
2. With the heater running, press and hold (+) and (-)
simultaneously until the display flashes.
3. Press (+) or (-) to select the amount of time you
would like the heater to run.
4. After setting the timer, the display shows a RED dot
next to current room temperature on the display to
indicate that the timer is activated.
5. The heater automatically shuts off after the
programmed length of time has passed.
FROSTPROTECT
TM
Press the "mode" Button 5 consecutive times for Anti Frost
setting (AF will show in the digital display). This special
setting is automatically activated when the (AF) mode is
selected. In this mode, the heater is off until the room's
temperature reaches freezing and the heater
automatically turns on HI power. The heater will cycle ON
and OFF as it maintains the temperature between 5-8 °C.
AUTO SAFETY SHUT-OFF
This heater is equipped with a technologically-advanced,
safety system that automatically shuts off power to the
heater when a potential overheat temperature is reached.
The heater can only resume operation when you reset it.
Reset the Heater
If the unit shuts down:
1. Unplug the heater and wait 30 minutes.
2. Plug in and turn on.
Tip-Over Shut-Off
If the heater is knocked over, it will instantly shut off. To
reset, simply place the heater in an upright position and
turn ON the heater.
Advertisement
Table of Contents
