Advertisement
SETUP GUIDE
CONNECTIONS
INPUT (PHONO):
The PHONO input accepts any standard
magnetic cartridge, stand alone turntable or
record player.
Connect your record player to the PHONO
input making sure to connect the thin black
GROUND wire to the silver GROUND
SCREW located on the bottom of the
iConnex, failure to connect the ground wire
will cause a humming to be present in your
recordings.
Once you have chosen which INPUT you are
going to use, make sure that the INPUT
SELECTOR SWITCH is in the appropriate po-
sition, LINE if you are using the LINE input or
PHONO if you are using the PHONO input.
OUTPUT:
The OUTPUT section allows you to use
the iConnex as an output for your computer
and can be used instead of your computers
built in output. You may then connect the
OUTPUT of the iConnex to any Mixer, Stereo
Receiver, Amplifier or any system with a LINE
level or AUX input. Then use the built in
THUMB WHEEL volume control located on
the side of the iConnex to adjust the volume
of the iConnex output.
Once you have made all the proper
connections you may then setup your
computer, although the iConnex is a PLUG
AND PLAY device there may be some
settings you need to go over depending on
your computers configuration.
For your computer settings and an Audacity RECORDING
SOFTWARE overview please continue to the next page.
(continued)
BOTTOM
Ground Screw
WARNING!
IF YOUR TURNTABLE
IS MISSING A GROUND
WIRE YOU MUST RE-
ATTACH ONE OR THE
TURNTABLE OUTPUT
WILL EMIT A HUM!
VOLUME
TOP
Make sure the
input select
switch is set to
the input you
are using.
Use the built in
THUMB WHEEL
to adjust the
output volume
Advertisement
